Tilta Connection Screw for 19mm Stainless Steel Rod Tilta

Podrobný popis

The Tilta RS19-C is a connection screw for Tilta stainless steel 19 mm rods: the external thread on both sides screws into the internal thread at the ends of two rods and joins them into one longer rod. In the middle it has a collar with a cross hole for tightening. Handy when the build is a few centimetres of reach short and no longer rod is at hand.

The Tilta RS19-C solves the case where the matte box or lens support sits a bit further than the rods reach: instead of buying a longer rod, another one is screwed onto the existing one and the rig grows centimetre by centimetre.

Two 19 mm rods into one

The screw has an external thread at both ends that fits the internal thread of Tilta stainless steel 19 mm rods. It is screwed into one rod, the second rod is turned onto the other end, and the cross hole in the middle collar lets you tighten the joint harder than with fingers. Joined rods then hold like one piece — firmly enough for a follow focus, matte box and lens support. The joint comes apart just as quickly, so the rods travel short and are extended only on set.

Tilta 15 and 19 mm rods

Rods are the backbone of a rig: 15 mm rods (LWS standard, 60 mm spacing) carry baseplates, follow focus, matte box, lens supports and motor mounts; 19 mm stainless rods (studio standard, 104 mm spacing) take heavy builds with large lenses. Tilta makes 15 mm rods in aluminium, black or silver, 100–300 mm long, and 19 mm rods in stainless steel, 200–600 mm; rods with threaded ends join end to end with a connection screw. This part is one of them.

• connection screw for 19 mm rods — 1×

• For rods: 19 mm, stainless steel
• Design: external thread on both sides, collar with cross hole in the middle
• Colour: silver
• Compatibility: Tilta RS19-200 and RS19-250 stainless steel 19 mm rods with internal thread (the RS19-450 has no internal thread)